-40%

Glass Mount Antenna UHF 450-470 MHz for Mobile Base Radio PL259 Tram 1187

$ 14.78

Availability: 955 in stock
  • Model: 1187
  • Compatible Brand: Vertex Icom Maxon Uniden Kenwood Midland
  • Refund will be given as: Money back or replacement (buyer's choice)
  • Connector: PL259
  • Number of Inputs: 1
  • Directivity: Omni-Directional
  • All returns accepted: Returns Accepted
  • California Prop 65 Warning: Cancer and reproductive harm - www.P65Warnings.ca.gov
  • Band: UHF
  • Color: Black
  • Item Weight: 2 lb
  • Return shipping will be paid by: Buyer
  • MPN: 1187
  • Restocking Fee: No
  • Item must be returned within: 30 Days
  • Compatible Service: For Mobile Two-Way Radio
  • Features: Multi-Directional
  • Condition: New
  • Compatible Product: Mobile/In-Vehicle Radio
  • Mounting Type: Glass
  • Type: Antenna
  • Country/Region of Manufacture: Taiwan
  • Brand: Tram-Browning

    Description

    UHF 450-470 MHz Glass Mount Omnidirectional Antenna with 17' of RG-58/U and installed PL259 connector. For Mobile radios. Model #1187.
    UHF 450-470 MHz 4.5 dBd gain. Pre-tuned.
    Max power 50 Watts
    VSWR less than 1.5:1
    Tunable
    Superior gain & wide bandwidth
    28 1/2" Height
    For Icom, Kenwood, Vertex, Midland, Maxon and other mobile radios.
    Important!!!
    You must not install it over defroster wires or on highly tinted windows.
    If the glass on your car is tinted from the factory, (tint in the glass), there will be no
    interference with the antenna's performance.
    Installation instructions:
    Decide where you want to mount the antenna and then wash and dry the window well, both inside and outside.
    Use an alcohol prep pad on both sides of the window and the mounting plates to clean anything off that your first wash missed. Make sure you give a minute or two for the alcohol to dry after you use it.
    Peel the protective plastic off the outside mounting plate and stick it to the window. Be careful to align the mount exactly where you want it – you have about 1 second to move it once it’s on the glass! BTW, the little threaded stud where the antenna whip is mounted goes UP!
    And the outside is stuck on, awaiting the antenna whip. Don’t put the whip on yet – the glue needs to set first.
    Repeat the plastic peeling / sticking with the inside unit. With the inside unit, make sure that the wire coming off of it is pointed the correct direction.
    Let everything sit for at least 2 hours so the glue can harden fully.
    Screw the whip on
    Note: Do not forget to check the whip tightness from time to time.
    We combine shipping. Please email or request a revised total from us if the calculated shipping does not look correct!!!